The long weekend is nearly here – time to break out the speakers for a poolside party. Check out Yes... Read the full story
2019-02-18 09:00 PM
Hello. We changed from Optus cable to NBN last week. Not painless at all but at last it seems to be working and stable hooray.
I have a Synology DS216SE NAS that won't connect. Normally you just plug the lan cable into the router and it is seen straight away on the network. But teh router wont see it. The router diagnostic page says "fail"on teh LAN port where the router is plugged in.
I have done all sorts of resets including complete reinstall of the router operating system. Changed cables, changed ports, did it upstairs, downstairs, with and without the dog in my lap, but nothing.
Does anyone have any ideas?
2019-02-19 10:10 PM
Quote: But teh router wont see it. The router diagnostic page says "fail"on teh LAN port where the router is plugged in.
What do you mean by this? Do you mean on the S@GEM when you plug in the Synology, it won't light up? or that inside the S@GEM config webpages it says "LAN FAIL?" (can you post a screen shot of what you are seeing?).
What happens if you plug something else into the same LAN port?
2019-02-20 10:29 PM
Thanks for the reponse. The screenshot of the diagnostic is below. The TV is plugged into eth1 and works fine.
The Synology NAS will not get the "pass" in any ethernet port (yes I tried eth1). And the TV works in any of the other ports.
I can connect to the NAS over ethernet from the computer, so the NAS ethernet works. It's just when the NAS is plugged into teh Sagecom that there is not spark between them.